Sip trunk setup trix box setup
This will now give the user the ability to dial the subscriber address of 4444 from the SIP Phone and will automatically be rerouted to his / her Exchange voice mailbox. If you right click the user mailbox you can enable Unified Messaging for it by enabling the extension number. This can be done directly in the Recipient Configuration of your Exchange Server Management Console. Now we have finished the basic configuration for allowing Exchange Server 2010 Unified Messaging to communicate with the Trixbox Asterisk Solution.Įnabling Unified Messaging for the Exchange User(s)įinally we now need to enable our user mailboxes for Unified Messaging. When you submit these settings, a Default Hunt Group will be created automatically within Exchange Server 2010.Īfterwards we will need to create a new UM Mailbox Policy:įor basic configurations we will finally need to define an Auto Attendant as follows: Now we need to configure a new UM IP Gateway with these settings:
![sip trunk setup trix box setup sip trunk setup trix box setup](https://static.ssl7.net/images/manual/SIPTrunk/en/freepbx-inbound-routes.png)
Numer of digits in extension numbers: 4 (but depends upon your configuration)įigure 9: Creating a new Dial Plan for Unified Messaging Now we need to have a look at what needs to be configured in Exchange UM role to interact successfully with Trixbox.Īt first we need to configure a UM Dial Plan with the following details: That’s it, your Trixbox machine is now successfully configured to support Exchange Server 2010 Unified Messaging.Ĭonfiguration of Exchange Server 2010 Unified Messaging Role If you then would like to test your configuration I would prefer using X-Lite and configure two users with SIP enabled and different telephone extensions.
![sip trunk setup trix box setup sip trunk setup trix box setup](https://static.ssl7.net/images/manual/SIPTrunk/en/freepbx-sip-trunking-diagram-dynamic-ip.png)
This allows internal communications for the dial patterns (in Exchange called “pilot identifiers” in the Unified Messaging Dial Plan). In addition we will need to add the corresponding outbound routes as follows: These settings allow insecure TCP based communications from your Exchange Server 2010 machine. Now we need to create a new Trunk to your existing Exchange Server box using the following Menu-Settings: PBX, PBX Settings, Trunks, Add SIP Trunk and use the following outgoing settings: You will need to add the following to settings to this file: You can edit this file using any Linux text file editior. This can be done by editing the file called SIP_GENERAL_CUSTOM.CONF located in etc/asterisk.
![sip trunk setup trix box setup sip trunk setup trix box setup](https://twilio-cms-prod.s3.amazonaws.com/images/Copy_of_Generic_Blog_Header_2-3.width-808.png)
To change to administration mode, you simply need to click on “Switch” on the upper right corner and logon as:Ĭonfiguration of Trixbox to Support Exchange Unified Messagingīefore configuring anything else, we need to enable SIP over TCP on Asterisk. After the installation has finished successfully you can now logon to Trixbox from any browser to configure it to work as an SIP gateway.